Boeing 737 MAX – Landing Gear - SmartCockpit - Airline training guides, Aviation, Operations, Safety

Fittings located in the opening of each main gear well:

Provide positive unlock during main gear retraction

Allows the landing gear transfer unit to use hydraulic system B pressure to raise the gear if hydraulic system A fails.

Are intended to provide protection to wheel well components during gear retraction by preventing a gear with a spinning tire and loose tread from entering the wheel well

Are intended to provide automatic braking to main gear wheels during retraction

Correct! Wrong!

Positioning the landing gear control lever to down makes system A hydraulic pressure available to the steering metering valve. Alternate nose wheel steering can be activated to provide system B pressure to the nose wheels when the NOSE WHEEL STEERING switch is placed to ALT, normal quantity is in the system B reservoir, and the airplane is on the ground.

True.

False.

Correct! Wrong!

Hydraulic system pressure from System B will be used to retract the landing gear:

When System A pressure is low and the landing lever is positioned UP.

After a failure of the No.1 engine hydraulic pump with the landing gear still down and the landing gear lever is positioned UP.

When the ALTERNATE NOSE WHEEL switch is positioned ON.

After failure of the No.1 engine with the landing gear still down and the landing gear lever is positioned up.

Correct! Wrong!

During alternate brake system operation, the following protection is provided:

Skid, locked wheel, touchdown and hydroplane.

Skid, locked wheel and hydroplane only.

Skid and locked wheel.

Skid and hydroplane only.

Correct! Wrong!

Both normal and alternate brake systems provide skid, locked wheel, touchdown and hydroplane protection.

Which statement is true?

Hydraulic system B pressure is bypassed with the lock out pin installed in the steering depressurization valve.

Rudder pedal steering is deactivated as the nose gear strut extends.

Rudder pedal steering allows 37 degrees of steering in either direction.

Rudder pedal steering overrides the steering wheel inputs.

Correct! Wrong!

The alternate anti-skid system has:

One alternate brake metering valve connected to all alternate antiskid valves.

Four anti-skid valves.

Two anti-skid valves.

Correct! Wrong!

The brake accumulator is pressurized by hydraulic system A. If both normal and alternate brake system pressure is lost, trapped hydraulic pressure in the brake accumulator can still provide several braking applications or parking brake application.

False.

True.

Correct! Wrong!

The brake accumulator is pressurized by hydraulic system B.

While the landing gear is being extended manually, the landing gear lever must be selected to:

OFF and then selected to DOWN after extension.

DOWN and remain DOWN after extension.

OFF and remain OFF after extension.

Correct! Wrong!

The brake pressure accumulator also provides pressure to maintain the parking brake when hydraulic system A and B are depressurized.

True.

False.

Correct! Wrong!

During taxi before takeoff, the amber AUTO BRAKE DISARM light illuminates. What should you do?

Position ANTISKID select switch to OFF. Use manual brakes in case of RTO.

AUTO BRAKE system is not mandatory. There is no limitation.

Position the AUTO BRAKE select switch to OFF. Do not attempt takeoff if light remains illuminated.

Position the AUTO BRAKE select switch to OFF and then reselect RTO. If light re-illuminates, use manual brakes in case of RTO.

Correct! Wrong!

What is the maximum airspeed to retract the gear?

210 kt.

270 kt.

235 kt.

250 kt.

Correct! Wrong!

If a landing is made with RTO selected:

AUTO BRAKE DISARM light illuminates 3 seconds after touchdown

Automatic braking occurs at the MAX level

AUTO BRAKE DISARM light illuminates 2 seconds after touchdown and no automatic braking action occurs.

Automatic braking action occurs at the RTO level

Correct! Wrong!

The parking brake is released by depressing the pedals until the PARKING BRAKE lever releases. A fault in the parking brake system may cause the ANTISKID INOP light to illuminate.

False.

True.

Correct! Wrong!

The nose wheel doors go from the open to the close position when the gear is down.

False.

True.

Correct! Wrong!

The nose wheel doors remain open when the gear is down.

After landing, autobrake application begins when both forward thrust levers are retarded to IDLE and Nose wheel and main wheels spin up.

True.

False.

Correct! Wrong!

The Nose wheel has no input.

With RTO selected, if the takeoff is rejected prior to wheel speed reaching _____ autobraking is not initiated, the AUTO BRAKE DISARM light does not illuminate and the RTO autobrake function remains armed.

60 knots

80 knots

72 knots

90 knots

Correct! Wrong!

If the takeoff is rejected after reaching a wheel speed of 90 knots, maximum braking is applied automatically when the forward thrust levers are retarded to IDLE.

Hydraulic pressure is removed from the landing gear system after 5 minutes with the LANDING GEAR lever in the OFF position.

False.

True.

Correct! Wrong!

There is no countdown. The hydraulic pressure is removed immediately with the LANDING GEAR lever in the OFF position.

The precharge pressure in the brake accumulator is:

1000 psi.

1500 psi.

1700 psi.

Correct! Wrong!

When the NOSE WHEEL STEERING switch is in ALT position:

The nose wheel steering tiller changes sensitivity for precision parking

Hydraulic system B provides power for nose wheel steering.

Standby hydraulic system provides power for nose wheel steering.

Hydraulic system A provides power for nose wheel steering.

Correct! Wrong!

With Flap 25 selected and the gear not down and locked, both Forward Thrust Levers are retarded to below approximately 10 degrees thrust lever angle. The gear warning horn sounds and:

Can be cancelled by moving one of the Thrust levers forward to approximately the 30 degrees thrust lever angle.

Cannot be cancelled by the Landing Gear Horn Cut-Out switch or by any position of the thrust levers.

Can be cancelled by the Landing Gear Horn Cut-Out switch.

Correct! Wrong!

If the landing gear cannot be raised after takeoff:

Use the override trigger.

When at a safe altitude follow the QRH procedure.

Pull the landing gear lever out to the second detent then raise it to the up position.

Land at the nearest suitable airfield.

Correct! Wrong!

Is autobrake available with alternate brakes?

Yes for takeoff only.

Yes for landing only.

Yes for takeoff and landing.

No.

Correct! Wrong!

Which pressure is indicated by the Hydraulic Brake Pressure Indicator?

Maximum pressure of 3500 PSI

Normal precharge of 2800 PSI

Normal pressure of 3500 PSI

Normal precharge in the brake accumulator of 1200 PSI.

Correct! Wrong!

Landing autobrake settings may be selected after touchdown:

Prior to decelerating through 30 kts of ground speed.

Prior to decelerating through through 60 knots groundspeed

However, autobrake action will occur only when both thrust levers are retarded to reverse thrust range

However, the AUTO BRAKE DISARM light will illuminate and autobrake application will not occur

Correct! Wrong!

The accumulator isolation valve is closed by:

System B pressure whenever system A pressure is lost.

System A pressure whenever system B pressure is lost.

Brake accumulator pressure whenever system B is lost.

Correct! Wrong!

Which of the following is not part of the braking system?

Antiskid protection.

Brake accumulator.

Parking brake.

Nose wheel brakes

Correct! Wrong!

What system normally provides hydraulic pressure for Nose Wheel Steering?

Standby system

System B

System A

Nose wheel steering accumulator

Correct! Wrong!

What is the steering authority for the rudder pedals?

+ or - 20 degrees

+ or - 7 degrees

+ or - 13 degrees

+ or - 5 degrees

Correct! Wrong!

What is the maximum Operating airspeed with the gear extended?

270 kt and .80M.

235 kt and .78M.

235 kt and .80M.

270 kt and .82M.

Correct! Wrong!

What airspeed must be considered with a wheel well fire situation?

Maintain 235 knots maximum for 20 minutes.

Retract landing gear speed of 245 knots maximum.

Observe extend limit speed (280 KIAS and .72M).

Observe extend limit speed (270 knots and .82M).

Correct! Wrong!

The air-ground system receives air-ground logic signals from:

The FMC position updating from the GPS

The altimeter

Six sensors, two on each landing gear

The cabin pressure controller

Correct! Wrong!

In flight and ground operation of various airplane systems are controlled by the air/ground system. These signals are used to configure the airplane systems to the appropriate air or ground status.

What is the minimum preflight pressure for the brake accumulator?

2500 psi.

3000 psi.

3500 psi.

2800 psi.

Correct! Wrong!

Antiskid protection is available even with loss of both hydraulic systems.

False.

True.

Correct! Wrong!

Antiskid system protection is provided during autobrake operation.

If a landing is made with RTO selected:

AUTO BRAKE DISARM light illuminates 3 seconds after touchdown

Automatic braking occurs at the MAX level

Automatic braking action occurs at the RTO level

AUTO BRAKE DISARM light illuminates 2 seconds after touchdown and no automatic braking action occurs.

Correct! Wrong!

What could cause the amber ANTISKID INOP light to illuminate?

AUTO BRAKE select switch OFF.

System B pressure is low.

A system fault has been detected by the antiskid monitoring system.

Brake accumulator pressure is in the red band.

Correct! Wrong!

Hydraulic pressure from System B will be used to raise the landing gear:

When System A pressure is low and the landing lever is positioned up.

When the No.1 engine RPM drops below a limit value with the landing gear still down and the landing gear is positioned up.

After a failure of the No.1 engine hydraulic pump with the landing gear still down and the landing gear is positioned up.

When the ALTERNATE NOSE WHEEL Switch is positioned ON.

Correct! Wrong!

If a main landing gear tire is damaged during takeoff, it is possible that braking of the main gear wheels during retraction may be affected. A spinning tire with a loose tread must be stopped prior to entering the wheel well or it can cause damage to wheel well components. When a spinning tire with loose tread impacts a fitting in the wheel well ring opening, that gear stops retracting and free falls back to the down position.

True.

False.

Correct! Wrong!

The parking brake can be set with only B hydraulic system pressurized.

False

True

Correct! Wrong!

The parking brake can be set with either A or B hydraulic systems pressurized. If A and B hydraulic systems are not pressurized, parking brake pressure is maintained by the brake accumulator. Accumulator pressure is shown on the HYD BRAKE PRESS indicator.

If the nose gear lockout pin is not installed

Pushback must be with System A Elec. pump OFF.

Pushback must be with both System A hydraulic pumps OFF.

Pushback must be with both System A hydraulic pumps ON.

Correct! Wrong!

Hydraulic pressure is removed from the landing gear system with the LANDING GEAR lever in the UP position.

False

True.

Correct! Wrong!

The hydraulic pressure is removed with the LANDING GEAR lever in the OFF position!

During landing gear retraction:

Snubbers in the wheel bays stop the rotation of all wheels.

The brakes automatically stop rotation of the main gear wheels.

The pilot applies manual brakes to stop main gear rotation.

A fitting in the wheel well opening applies a braking force to the wheels.

Correct! Wrong!

Landing Gear Indicator Lights - What does this indication mean?

Landing gear is not down and locked. Related landing gear is in disagreement with LANDING GEAR lever position (in transit or unsafe).

Landing gear is not down and locked (with either or both forward thrust levers retarded to idle, and below 800 feet AGL). Related landing gear is in disagreement with LANDING GEAR lever position (in transit or unsafe).

Landing gear is not down and locked (with either or both forward thrust levers retarded to idle, and below 1000 feet AGL). Related landing gear is in disagreement with LANDING GEAR lever position.

Landing gear is not down and locked (with thrust levers in idle, and below 800 feet AGL). Related landing gear is in disagreement with LANDING GEAR lever.

Correct! Wrong!

If the thrust levers are advanced after touchdown:

The AUTO BRAKE DISARM light will not illuminate.

The AUTO BRAKE DISARM light will illuminate immediately.

The AUTO BRAKE DISARM light will illuminate after 3 seconds.

The AUTO BRAKE select switch will move to OFF.

Correct! Wrong!

The alternate brake source selector valve:

Prevents hydraulic system A from powering the alternate brake system when hydraulic system B is operating normally.

Isolates accumulator pressure.

Prevents hydraulic system B from powering the alternate brake system when hydraulic system A is operating normally.

Correct! Wrong!

The HYD Brake Pressure indicator reads zero, but both hydraulic system pressures are normal.

The nitrogen precharge in the brake accumulator has leaked out, normal braking is not available but alternate braking is unaffected.

The nitrogen precharge in the brake accumulator has leaked out and alternate brakes will not be available in the event of system B failure.

The nitrogen precharge in the brake accumulator has leaked out, accumulator braking is not available but normal braking is unaffected.

Correct! Wrong!

The autobrake system performs a self-test at initial AC power application. If the self test is not successful, the AUTO BRAKE DISARM light illuminates and the system does not work.

True.

False.

Correct! Wrong!

When the manual extension access door is open:

Normal landing gear extension is still possible if hydraulic system A pressure is available

Landing gear retraction is enabled.

Normal landing gear extension is still possible if hydraulic system B pressure is available

Manual landing gear extension is possible with landing gear lever in any position.

Correct! Wrong!

The alternate brake system is powered by:

System B hydraulics.

Accumulator pressure.

System A hydraulics.

Correct! Wrong!

Landing autobrake settings may be selected after touchdown prior to decelerating through _____. Braking initiates immediately if both forward thrust levers are retarded to IDLE and the main wheels spin-up.

30 kts of ground speed.

40 knots IAS.

30 knots.

40 kts of ground speed.

Correct! Wrong!

What happens if you reject a takeoff after reaching 90 knots with the autobrakes in RTO?

Maximum braking when thrust levers are retarded to idle

Automatic braking when reverse thrust selected

AUTO BRAKE DISARM light will illuminate

Automatic speed brake deployment when thrust levers are retarded to idle

Correct! Wrong!

The landing gear indicator lights found on the center panel will illuminate red when:

All landing gear are DN and the gear handle is in OFF position

There are no red lights.

One of the 6 green lights is inoperative..

All landing gear are UP and the gear handle is in OFF position

Correct! Wrong!

Boeing 737 MAX – Landing Gear